Crashday Not Operating

"DX9 Error - Graphics system layer 1.00"
I Saw that this has been discussed earlier also on this forums so coming to point here are my specs please tell me
Operating System: Windows 7 Ultimate 32-bit (6.1, Build 7600)
System Manufacturer: Kobian
System Model: PI945GCM
BIOS: Default System BIOS
Processor: Intel(R) Pentium(R) Dual CPU E2180 @ 2.00GHz (2 CPUs), ~2.0GHz
Memory: 2048MB RAM
Available OS Memory: 2040MB RAM
Page File: 1151MB used, 2927MB available
DirectX Version: DirectX 11
DX Setup Parameters: Not found
User DPI Setting: Using System DPI
System DPI Setting: 96 DPI (100 percent)
DWM DPI Scaling: Disabled
DxDiag Version: 6.01.7600.16385 32bit Unicode
Display Devices
---------------
Card name: Intel(R) 82945G Express Chipset Family
Manufacturer: Intel Corporation
Chip type: Intel(R) 82945G Express Chipset Family
DAC type: Internal
Device Key: Enum\PCI\VEN_8086&DEV_2772&SUBSYS_26331019&REV_02
Display Memory: 256 MB
Dedicated Memory: 0 MB
Shared Memory: 256 MB
Current Mode: 1600 x 900 (32 bit) (60Hz)

 

Additionally, your graphics chipset was designed circa 2003/2004 and there is no way that it will fully utilise Directx 10 or 11 (at worst, it will run in an emulated (software) mode (very slow)),crash or fail to load when trying to play recent games.

Set the desktop resolution and game resolution to 16 bit for the best chances of getting a game to run. Download the latest drivers from Intel (Windows drivers have no OpenGL support). On Vista, Crashday with 1.1 patch and the no Intro patch were needed, though there may be better patches now.

 

Okey Thx
I will try

but 16-bit rolleyes ?????
isn't it really very low?

 

LOL. 16 bit sounds low but it's not as bad as you think, it's the most compatible and uses less video RAM so gives you the best chance

 

I have the same problem, but I run Vista. When I look at the crashwin log file it says File Missing or Corrupted! (file crshpath.ini) which is the file that tells the game where the application is. I get the same error message, but how is the message connected to the log file? I don't understand it.