Dell Workstation 670 Hard Drive invisible detected while installing windows 7

i have problem with Dell Precision Workstation 670 to install windows 7 64bits. in fact i had already installed Windows 7 64bit and Ubuntu operating systems on the newly hard drive. when the power cut down, windows 7 64bit didn't boot up at all, it says that Bios installed successfully and Battery voltage is low. At the same time Ubuntu is booting up and working fine but Windows 7 64 bits does not boot up, when i try to re-installed Windows 7 64bit , there is no hard drive visible / detected during the installation process !

At the start up i received following message.
----------------------------------------------

CERC SATA 25 BIOS For Non-Hotplug Drivers V2.1-11 2824

<<< Press <Ctrl><A> for Adaptec RADI Configuration Utility!>>>

Controller #88: CERC SATA 2S Bus:88; Dev:1F, Func: 82

Loading Configuration...Done
Port#88 SAMSUNG HD183SJ 1AJ18881 431.51 GB Healthy

SATA JBOD- PORT-B SAMSUNG HD183SJ 431.51GB Legacy

1 JBOD Device(s) Found.

BIOS installed successfully!

------------------------------

Though i have replaced motherbroads' battery with new one , but still i am receiving same message at the start up of windows 7 64bit while booting up, whereas, on the other hand Ubuntu is working fine and am able to access the data files stored on hard drive.

Any help how to resolve this issue of booting up Windows 7 64bit or re-installing Windows 7 64bit again !!!