Dual monitor support. Lcd and vga

I just purchased an Acer 19" LCD very sweet monitor, though I don't think I'll buy an lcd again. Like the look of the CRT better. Anyhow, I always used dual monitors before the lcd and now when I try the crt becomes the primary monitor. I can force the lcd to be the primary but then my icons are messed up and dragging anything to the secondary monitor is all backwards.

Am I correct in assuming that since they are two different monitors that I will not fix this issue? I did run the lcd with the vga port and all was fine except for the screen getting very glitched until I cut the power to it and turned it back on. Any suggestions?

 

Hard to believe I am the only person to see this.

 

I am curious about this problem also as if i buy a LCD ill have that and a 19" CRT sony.

 

You can drag the order in which the monitors appear. For instance, note the two screenshots. Then dragging won't be backwards.