Mercury ADSL router

have purchased a Mercury ADSL router ART18CX that I am trying to configure to use with my 2 computers, using a Freeserve Broadband connection. The problem is the lack of any technical support, it all has to be configured manually without the aide of any useful information on what settings to choose, here is an example

WAN Configuration


--------------------------------------------------------------------------------

System Wide Settings


Default Gateway




--------------------------------------------------------------------------------

Per VC Settings


Enabled? VPI VCI Static IP Address Subnet Mask
No Yes

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

MAC SPOOFING
Mac Spoofing Disable Enable
Mac Address

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

ATM
Service Category UBR CBR
Bandwidth kbps

--------------------------------------------------------------------------------

ENCAPSULATION PPPoA VC-Mux PPPoA LLC 1483 Bridged IP LLC 1483 Routed IP LLC 1483 Bridged IP VC-Mux 1483 Routed IP VC-Mux Classical IP over ATM PPPoE VC-Mux PPPoE LLC PPPoE None

--------------------------------------------------------------------------------

BRIDGE Disabled Enabled

--------------------------------------------------------------------------------

IGMP Disabled Enabled

--------------------------------------------------------------------------------

PPP
Service Name
Username
Password
Disconnect Timeout seconds (Max:32767)
Authentication CHAP PAP Auto
Automatic Reconnect

--------------------------------------------------------------------------------

DHCP
DHCP client enable
Host Name



--------------------------------------------------------------------------------

Virtual Circuit: 0 1 2 3 4 5 6 7



Settings need to be saved to Flash and the system needs to be rebooted for changes to take effect.

Save Configuration




Does anyone out there know anything about configuring this router or can someone point me in the right direction for tech advice.

Thanks in anticipation
FBW

 

I believe that this model of ADSL Modem is the same as the Kobian AUS18CX. You can get the manual there and it might have a FAQ.