SnapGear SG300 Setup VPN to work with TheGeenBow Client

Hi

I have got this scenario ,,,ADSL modem Netgear router its LAN ip address 192.168.1.1 and one of its LAN port connected to a WAN port of SnapGear SG300 (192.168.1.2),,,,,,,,,,,here is my confusion during VPN setup I have to use many IPs which one should I chose (double natted) ,,,,could you please someone walkthrough the snapshots below to help me out if he/she finds any incorrect settings


http://www.snapgear.com/index.cfm?skey=1556

LAN ip address for SnapGear SG300 is 192.168.0.1

I tried hardly to find any online documentation , the only site that I found was below

http://quark.humbug.org.au/publications/notes/bofh/msg00038.html


I did my best to configure IPSec for SnapGear SG300 as below (I could not figure out where is my mistake):

1- Tunnel settings



http://img196.imageshack.us/i/tunnelsettings.jpg/


2- Local Endpoint settings



http://img269.imageshack.us/i/localendpointsettings.jpg/


3- Remote Endpoint Settings



http://img689.imageshack.us/i/remoteendpointsettings.jpg/


4- Phase 1 Settings


http://img691.imageshack.us/i/phase1settings.jpg/


5- Phase 2 Settings


http://img4.imageshack.us/i/phase2settings.jpg/




I used TheGreenBow VPN client utility ,,,,,my configuration as below :

1- Phase1advanced



http://img33.imageshack.us/i/phase1advanced.jpg/


2- Phase1 Authentication



http://img269.imageshack.us/i/phase1authentication.jpg/


3- Phase 2



http://img269.imageshack.us/i/phase2b.jpg/


By looking at those snapshots I would appreciate any hint or tip where I did misconfigure although I will try to post logs for both router and TheGreenBow.

Thanks

 

Sorry for the bad phrasing in my early thread , I will try to explain what I am trying to achieve

I have got this scenario ,,,netgear ADSL modem router connected to my ISP, its LAN ip address 192.168.1.1 and one of its LAN port connected to a WAN port (192.168.1.2) of a SnapGear SG300 (please see the link below for this router)

http://www.snapgear.com/index.cfm?skey=1556

LAN ip address for the SnapGear SG300 is 192.168.0.1

http://www.scribd.com/doc/3800513/NetGear-FVS318v3-GreenBow-IPsec-VPN-Configuration

In the link above I was able to configure TheGreenBow VPN Client to connect to a Netgear router FVS318

but in my this scenario I do not have Netgear router FVS318, instead I have got Snap Gear SG300,,,,,,I did my best to configure the IPSec for SnapGear SG300 as in the snapshots below (I could not figure out where is my mistake), my confusion during VPN configuration I have to use many IP addresses, but I was not sure which one should I choose (be aware there is double natted ).

Can someone walkthrough the snapshots in my early thread