BIOS PS setting

I have a CNC machine with a M6VLR ver3.0 motherboard. The CMOS battery died & my BIOS settings appear to have reset to the defaults.
This machine doesn't use a power button at the controller, so when the machine is powered up & the contactor sends 120v to the power supply, the motherboard should boot up.
I took a power button off of an old PC & plugged it onto the correct pins to get into the BIOS so I can change the settings. But I can't figure out what setting in the BIOS bypasses the JPANEL1 pins.
Any one know what setting needs to be changed?

 

I figured it out.
It turned out to be kind of backwards, I had to change the setting for the 'State After Power Failure' setting, from 'Off' to 'On'.