Diskeeper lite installation???

Hi Guys

I have just tried to install diskeeper lite from major geeks website but upon installation I get the following error message and don't know how to finalise the installation. Can anyone help?? Using win xp pro.

"Error 1402 Could not open key
Unknown\DfrgSnapin.DfrgSnapin.1\CLSID
Veriify that you have sufficient access to that key"

I don't know what this means. I have installed this programme on other computers (although they were win98)

Thanks
Wombat

 

Try the steps below, see if it helps.

1. Go in the registry editor. The top most folder listed is HKEY_Classes_Root.
Right-click on this folder and select PERMISSIONS from the menu.
2. Once there, look through the permissions listed and make sure that
Administrators and System are both listed. If they are not, please refer to
the bottom of this write-up under "Conditional Step".
3. If they are both listed, make sure that both have Full Control
checked on ALLOW. If they are not yet checked, click in that box and select
APPLY. This will put the proper permissions through the registry and should
set you up for a good installation. Once finished with this area select OK
and close the Registry Editor.
4. Once done, retry the installation of Diskeeper.

Conditional Step

If you've found that System and/or Administrators are not listed in the
permissions section, you will need to add them. To do so, click the Add
Button and in the following screen type System or Administrators depending
on which is missing. (You may only do one at a time). Once typed, select the
CHECK NAME button which will end up highlighting the name and then you can
select OK.

Steve

 

Thanks Matacumbie. The installation advice worked fine.
Regards
Wombat

 

You are welcome, glad it worked. .

Steve