Having problem with Jumper on HD

OK I was given a free computer to fix up. Now I got it running now my problem is that when I boot it up it goes to the bios then I exit it it says to fix the jumper and restart the computer. Ive tried putting the jumper a couple different ways but cant figure it out. I drew a picture for refrence its a 10 pin how should I set the jumper to get this beast working. Also its a Western Digital Drive.

http://http://img136.imageshack.us/img136/5053/fdsagsdsw5.jpg

 

I was just looking at a WD400 western digital hard drive and the jumper was set to the first 2 pins running vertical beside the power in port. which acording to the jumper settings on the top of the harddrive is set to Cable Select. So pin 1 and 2 are jumpered.

 

This link might help you out.

http://wdc.custhelp.com/cgi-bin/wdc...Xh0PWp1bXBlciBzZXR0aW5ncw**&p_li=&p_topview=1

E