My SiSandra Test Result

nalysing...
Tip 2546 : Large memory modules should be ECC/Parity.
Notice 5901 : CD 1x= 150kB/s; Exercise caution when comparing measured versus published ratings.
Notice 5902 : DVD 1x= 11.08Mbps Exercise caution when comparing measured versus published ratings.
Finished Successfully : Yes

Mainboard
Analysing...
Notice 224 : SMBIOS/DMI information may be inaccurate.


Tip 2546 : Large memory modules should be ECC/Parity.
Warning 2544 : System/Video shared memory greatly reduces performance. Use external video card.
Finished Successfully : Yes

Plug & Play
Analysing...
Finished Successfully : Yes

Mainboard Configuration
Analysing...
Notice 224 : System BIOS : SMBIOS/DMI information may be inaccurate.
Tip 212 : System BIOS : BIOS can be shadowed so check whether it is.
Warning 214 : System BIOS : BIOS is flash-able but surface-mounted. An unsuccessful flash may be fatal.
Warning 208 : System BIOS : BIOS does not support the EDD (Enhanced Disk Drive) specification. Check for an update.
Finished Successfully : Yes

Processors
Analysing...
Notice 224 : CPU 1 [Processor 0, Core 0, Thread 0] : SMBIOS/DMI information may be inaccurate.
again no idea how to handle this

Buses and Devices
Analysing...
Error : CardBus Bus 3 (1/1x BClk) : No devices found. : No devices found.
I am not sure what this means, my computer is functioning properly for a long time, wonder if this is needed

Power Management
Analysing...
Notice 224 : SMBIOS/DMI information may be inaccurate. HP notebook they have no updates for this catagory were does someone with an out of warranty machine get something like this




Tip 319 : Video Adapter : Primary Display Driver (display) : A refresh rate of at least 75Hz is recommended. Increase it if possible.
It wont allow me to change to 75hz is this a big deal


Tip 319 : Video Adapter : Intel(R) 82852/82855 GM/GME Graphics Controller (\\.\DISPLAY1) @ \\.\DISPLAY1 : A refresh rate of at least 75Hz is recommended. Increase it if possible.same no option

Finished Successfully : Yes

Physical Disks
Analysing...
Warning 3101 : ST94xxxA (ATA) : Power management enabled. Consider disabling on desktops.


DOES ANYONE SEE SOMETHING CRITICAL OR NEEDING TO FIX soon?
I really dont understand most the terminology what is ECC Parity?
I am a novice so bare with me thank you guys for helping once again

 

Parity checking provides single-bit error detection for the system memory, but does not handle multi-bit errors, and does not correct memory errors. An advanced error detection and correction protocol was therefore invented . Called ECC, which stands for error correcting circuits or error correction code, this protocol not only detects both single-bit and multi-bit errors but will correct single-bit errors.

You have on-board video rather than a separate card. Don't worry about it.

No not a big deal it's just that the high the refresh rate the better in general.

So basically if everything is working then there is no need to panic.

 

yeah I really appreciate your help, I guess I am an obsessive worry wart about security and PC care, since well I paid so much for it.

so from those results you dont see anything too serious???

 

Nope nothing at all.

Have a great 2007 and I hope all your PC problems are small ones.