power button and leds

i just bought a new case (http://www.thermaltake.com/product/Chassis/midtower/soprano/vb1000sws.asp) and the power switch and led connectors are not all together and im not sure where each one goes i know where on the motherboard i put them but in what order. so far iv got the power button but what about the leds? i have a Asus M2N68-LA motherboard any help thx.

 

The mother board manual will tell you exactly where everything goes on the board. I also have an Asus board and my book gives very detailed instructions.

 

i cant find the manual on the internet

 

Same here. Can't find much for the 9 pin front panel connector on this motherboard. (Also known as an HP Narra2-GL8E.)

You've got the power button connected, there are only three connections left. (Reset button, power LED, and HDD LED) How did you determine the power button connector location? Is there any connector info silkscreened onto the board for the connectors? There usually is.

If you determine the LED pins, and they don't work, rotate the connector 180 degrees.(With the power off. I've done this with machines running as they are only LEDs, but do as I say, not as I've done.) ;>)

 

i googled your motherboard and one of the sites was an hp site and it gave a diagram of your motherboard model# i hope it helps. http://http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01080282&lc=en&cc=us&dlc=en