Zone Alarm and networking question.

When i have zone alarm running i cannot connect or see any of my other computers or my printer on my network. Is there some setting i have to set to allow me to be active on the network? I have tried out the firewall settings, but it will only work on Low which means the firewall is turned off.

Any help is greatly appreciated.



cooked

 

anyone? I think i have to allow the access only for each computer somewher but i dont know where.



cooked

 

When I was using ZA, I just set up some expert rules to allow incoming/outgoing connections to IPs on the network. I can't remember where that bit is [sorry]... Think it was in the firewall section under "Expert Rules"...

hope thats some help.

(I wasn't sure that was totally wise, so I changed to Sygate and had no problems)

-All the best

Ciz

 

ZA usually asks you what to do when it discovers a network. But put you LAN in a trusted zone & not Internet zone.