how do you set jumpers on super slocket 3 cpu card

I want to use this card on my Biostar M6TBA V1.5
Im using Intel p3 866/133/1.7v.
Does anybody know how to use the Jumper settings...
This is the info that i found....

Intel PIII Coppermine/Cyrix/Celeron to Slot 1 Adapter)
→ Product Specifications
Use Intel/Cyrix PPGA&FCPGA 370 CPU on Slot 1 M/B Works with all of the Slot1 M/B
Support 66/100/133 MHz CPU bus clock
Support all Intel/Cyrix PPGA(FCPGA) Celeron & Coppermine
Sopport Dual/Single CPU
→ Jumper Settings
1 ■■□3 JP1
1 ■■□3 JP4
1 ■■□3 JP5
1 ■■□3 JP2
1 ■■□3 JP3
(default Jumper Settings)

CPU CLK
66MHz JP1(2-3) JP4(2-3)
100MHz JP1(X) JP4(2-3)
133MHz JP1(X) JP4(X)
AUTO JP1(1-2) JP4(1-2)

CPU BRAND
INTEL JP2(1-2) JP5(1-2)
CYRIX JP2(2-3) JP5(2-3)

CPU SD/DP MODE
Single CPU JP3(1-2)
Dual CPU JP3(2-3)
**********************
qUESTION 1.--ON JP1 FOR 133 WHAT DOES X MEAN....???
I removed the jumper on jp1 n jp4 but system failed to boot....
I replaced them...system failed to boot....ANY HELP GUYS...?????
it first booted fine on default settings---pic above----but read 533mhz so i moved the jps and thats how i got here ...
CAN somebody help me out..please...

 

I have seen X stand for 'don't care' and for 'No Jumper'. In the no jumper case it is normal to set the jumper on one outer pin only so it is still available for future use.

You won't hurt trying combinations, It just won't work at the wrong settings.

 

Dude what settings would you recommend....??

 

JP1 no connection or 1-2

JP2 1-2

JP3 1-2

JP4 no connection or 1-2

JP5 1-2

so they could all be in the default position.

HOWEVER YOU MUST ALSO HAVE A SECOND
SET OF JUMPERS FOR THE MULTIPLIER.

This may well be a DIP switch not jumpers.
Set it for a multiplier of 6.5

 

What dip switch..on the board..where????

 

the only manual I can find only goes up tpo version 1.3 and doesn't offer a 133 processor bus.

It uses JP4 (page 1-20) to set the processor FSB and speed.
JP4 is found on the edge of the board,near the battery, between the ROM bios and the primary IDE connector.

For this versionset pins of JP4 as follows for a multiplier of 6.5

1-2 open
3-4 open
5-6 closed
7-8 closed
9-10 open

 

Now it wont boot to bios....weierd huh ...
I went back to the settings it had when i first tried it out..
1-2-closed
3-4-closed
5-6-open
7-8-open
9-10-open

and nothing either....
Ill kkep tinkering until i blow the dam thing up...