"index out of bounds"

Hello,

I have an issue that possibly/HOPEFULLY someone here may be able to help with but was not sure where to post it:confused.

I have installed a CAD-CAM program that runs an add-on program called Preditor from inside the software or as a stand alone program.

When I select a command to "edit CNC" from the CAM program I get "index out of bounds". This has been frustrating because neither the sofware people "Bob-CAD" or "preditor" can figure this out.

I have been looking for some sort of help for this or a removal tool or bug fixer to take care of this but not much luck. I ran accross this forum while googling my issue. I hope someone here may have a remedy for this. Any help is most greatly appreciated.

Bob-CAD also would like to know of any fix I came up with so if there is any software people out there with a fix. Now is your time to shine!
Thanks in advance,
Mike

 

Hello,
I cannot help with this but one thing you should never do is post an email address on a forum unless you are ready to get loads of spam.

There is a forum that has a thread related to yours here.

 

Opps. forgot about the email. Can someone delete this from my post!

Thanks!

 

Thanks for removing the email address David!